Peugeot 308 Key Fob Replacement

Peugeot’s 308 is a bit old but it’s still striking. It’s not the most luxurious vehicle in its class, but it is an enjoyable and relaxing drive.

We are often asked at Coded Car Keys to replace peugeot key fobs. Whether the problem is constant or intermittent, the following tips should help.

Water Damage

If you accidentally drop your key fob into an eddy, or it is wet while kayaking, canoeing, rafting or canyoning the fob is more likely to be damaged by water. The best method to prevent this from happening is to keep it in a dry bag when you’re out in the open or engaging in things where the fob might be exposed to high levels of water.

It’s also important to make sure that the fob is completely dried out before you open it and use it again. If you notice any smells emanating from the fob (such as industrial fluid or windshield washer fluid), this is another indicator that it is submerged.

A circuit board that is wet could cause the battery to discharge its energy or even explode. If you’re able to pull your key fob 308 out of whatever body of water it was stuck in then flip the button side down and shake out as much water as possible before opening the case. Take the battery out, and then wipe the circuit board clean with a cotton swab that has been dipped in 90-percent alcohol.

Other reasons why your peugeot key fob not working 308 remote keyless entry system may be unable to function could be due to a dead coin battery problems with the receiver module signal interference, a faulty electronic chip. If none of these are the issue, you can reset the system by disconnecting 12 Volt battery from the car for 15 minutes.

Dead Coin Battery

Peugeot cars come with a remote-start system that allows the driver to start the car from afar and then warm up or cool down the vehicle prior to entering. This feature is extremely useful particularly during the cold winter months. However, there are times when the remote start system stops functioning due to a variety of reasons, like a dead coin battery.

The coin-shaped battery that is inside the key fob could last between two and four years, based on the frequency with which it is used, where it was purchased and how it is utilized. The date for use-by will be printed on the package or mentioned in the user’s manual.

If the key fob has stopped working after being exposed to clean tapwater, remove the battery and clean the electronic chip using the aid of a towel soaked in isopropyl ethanol. Then, dry the chip thoroughly before replacing. If the key fob has been exposed to salty or soapy water, it could have caused the chip to become damaged. You’ll need to replace it.

If you’re unsure if the battery is defective, you can check its voltage with an instrument connected to the terminals for plus and minus. If the voltage is less than 12-13 volts, you should replace the battery. You can also reset the computer that is onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should start.

Faulty Receiver Module

If you’re not receiving the “Key Detected” message on your dashboard, then it’s possible that your receiver module has been afflicted with a fault. It’s the part which sends out the signal when your key fob is activated. It also acts as an alarm and blocks the car from starting if it doesn’t have the correct key.

This can be due to many factors, including water damage or just getting old. If your Peugeot 308 key fob has been exposed dirty tap water, as in, the electronic chip on the inside will be damaged. In this instance, you’ll have to take it off and thoroughly clean it with isopropyl or electronic cleaner. When the battery is clean, you can try again.

If the issue continues to persist then it’s a good idea to seek out a local peugeot van key specialist or locksmith. They’ll be able employ a diagnostic tool identify the issue and fix it.

It is stressful to lose your Peugeot car key Cover peugeot key. However, a trained auto locksmith can address the issue in a matter of minutes. They can program your car and cut a new functioning key for you. Click here to locate locksmiths near you.

Electronic chip that is malfunctioning

The electronic chip inside the peugeot partner key fob replacement 308 key fob is an important part of the remote control system. If it is damaged your car might not start or you may receive a message saying “anti-theft active”. In this case, the only solution is to replace the key. Luckily, professional auto locksmiths can offer the service within the shortest period of time.

The chip inside the key fob of your Peugeot 308 may fail due to different reasons, such as water damage, sweat or dirt. If your peugeot 108 key cover key fob has been exposed to dirty or soapy water, it needs to be cleaned immediately. You can wipe the electronic component using paper towels soaked with isopropyl Alcohol. Then, you need to allow the battery to completely dry.

Sometimes keys can cease to function due to radio interference. This can happen when other devices operate on the same frequencies as your peugeot 307 replacement key keyfob. It could be caused by problems with the environment or objects within the vicinity of the vehicle. If you have this issue it is advised to visit a Peugeot dealership.

The Peugeot Key Fob 207/308 is delicate and requires particular care. You should not drop it or throw it around. If you lose it, try to locate it as quickly as is possible. You can reset the onboard computer by disconnecting the battery for a few minutes. Disconnect the negative cable before the positive.