Peugeot 208 Key Replacement

Peugeot 208 key replacement car keys peugeot is best left to professional auto locksmiths who have the appropriate equipment and technical knowledge. They can create and program keys quicker and more efficiently than dealers.

If the key fob stopped locking or unlocking your doors it could be due to a dead coin battery. There are also other reasons for the key to be malfunctioning.

Dead Coin Battery

A dead battery in the coin compartment will prevent your Peugeot 208 from locking or unlocking, and won’t start the engine. In this case you’ll have to use the alternative starting method described in your vehicle owner’s manual.

Another reason why your 208 might not start is because the spark plugs have worn down. Spark plugs are what ignite the fuel to start the engine. They only last for a certain amount of time. If they’re not used enough they will eventually fail.

There is a simple solution for this issue. Verify the voltage of your battery using a multimeter. If it’s below 11.5 volts and you are not satisfied, then it is time to replace it. It is also important to clean the battery’s contacts if it has corrosion. This can be done by removing the rubber covers from the two battery terminals and then using a wirebrush, you can remove any parts of the battery that are corroded. Then, you must reconnect the positive pole cables to the negative.

Water Damage

If your 208 will not start and the battery has not been replaced, you must inspect the spark plugs. It could be that they’re dirty and do not spark. The spark plugs can be cleaned in a workshop.

Peugeot cars have a transponder key that works with the car’s immobiliser system. This makes sure that only the correct key can start the engine. If the chip in the Peugeot key is damaged, it will not send the proper signal to the vehicle.

Water damage is the most common cause of this issue. This is especially prevalent in colder climates where the vehicle could have been exposed to rain or snow. If this is the case, you should get in touch with a reputable locksmith who has all the equipment and tools needed to modify the new key. They’ll also have the latest technology and machinery required to create the peugeot 208 key fob smart key. The process should not take more than 15 minutes.

Contacts for the battery that are defective

Peugeot changed from the old carbon-encased transponder chips to a new type of chip that incorporates electronic components on circuit boards. The new system is fantastic in its initial state, but the circuit boards begin to degrade with time and stop working properly.

This can prevent the immobiliser chip from working the immobiliser chip, causing your car not to start. If this happens it’s a good idea get in touch with a Peugeot specialist or locksmith.

The most frequent issue is when the battery of the key fob starts to fail. This causes the blade of the key to stop feeding into your lock. A locksmith in your car can replace the battery and cut a new blade for you, it’s typically a quick fix.

Faulty Receiver Module

If your peugeot 308 key fob key fob was not working after dropping it on the ground, being exposed to a sudden downpour or accidentally washing it may be due to a malfunctioning receiver module. The receiver is responsible for sending radio frequency signals to an on-board computer, which controls the central locking system of your Peugeot vehicle.

The key fob itself is fitted with rubber seals which prevent water from getting to the electronic chip inside. The chip can be damaged by water when it is exposed to water for a prolonged period of period of. Submerging the key fob into ocean water at the beach or throwing it into the pool can be particularly damaging due to the high salt content.

The module must be replaced if the Peugeot spare key does not work anymore. This can only be done by a Peugeot specialist or expert auto locksmith. Peugeot keys, unlike other cars, are secured by an immobilizer device. This requires the correct programming to allow the car to start. This is why you should only trust an experienced Peugeot locksmith to handle the task of programming and creating an alternative.

Computer with a problem on board

The on-board computer of your Peugeot 308 Key Replacement is responsible many functions in your car including power windows and airbags. The on-board computer displays an error code when something goes wrong. This code is stored inside the system and stays there until the issue is fixed. Often, this will involve replacing the on-board computer.

One of the most common reasons for the airbag light turning on is loose or corroded connectors in the airbag sensor. This could be due to wear and tear, ageing or exposure to salt and moisture. It is imperative to have this issue resolved as soon as possible, as a malfunctioning airbag can be dangerous in the event an accident.

If you see an error message stating that the card is not found on your Peugeot key fob, the battery in the key fob might be weak or dead. This will prevent the key fob from sending a signal to disable the immobilizer on your vehicle’s standard. Try this by pressing the unlock button on the key fob and then trying to start your car. If this fails, then the key battery will need replacing.